Sim2 HT5000 Manual do Utilizador descarregar pdf (Página 4)

1.2 Setting up the TCP/IP connection

The control system (or the PC) can establish a TCP/IP connection to the SIM2 HT5000 projector. The

basic steps required to add the projector to an existing Ethernet Networks are listed below.

• Make sure the site has an Ethernet switch or router with a free 10BASE-T (10 megabits per second)

or 100BASE-TX (100 megabits per second) port for the projector.

• Make sure a CAT5 (or better) twisted pair Ethernet cable with RJ-45 connectors is available. Check

that the maximum cable length requirement (100 meters or 330 feet) is met. Test the cable for proper

wiring.

• Switch on the projector and make sure there is not a valid signal on the selected input (the OSD

displays the ‘No signal’ message). Enter the ‘Setup | Network Settings | IP Conﬁguration’ page.

Assign the numeric IP Address (either Static or obtained using DHCP) of the projector and the Port

1 number. Select ‘Apply settings’.

• Open the Control System (or the PC communication program) conﬁguration panel and enter the

numeric IP address and the port number you got in the previous step.

• Power cycle the projector (make sure the cool down routine has ﬁnished before switching oﬀ the main

switch).

1.3 Execution of the command

Command execution time may vary from 0.1 to 2.0 seconds, depending on the operation that have been

requested.

If the projector is busy when a command is sent, the unit may not accept the command. When several

commands are to be sent one after the other, suﬃcient time between them should be allowed.

When the projector is switched on from Standby, wait 40 seconds before sending commands to the projector

or reading messages sent by the projector.

1 2 3 4 5 6 7 8 9 ... 13 14

Sem comentários

Sim2 HT5000 Manual do Utilizador Página 4